Virtual Experiment For the purpose of texercise, you are not required to physically perform the experiment. Data will be generated using the virtual simulation on the website indicated below https://phet.colorado.edu/en/simulation/capacitor-lab Procedure Task 1 1. Go to the following address: https://phet.colorado.edu/en/simulation/capacitor-lab 2. Download the Capacitor Lab and run the simulation 3. Under the Meters tab on the right of the simulation window, select the following tick boxes: Stored Energy Voltmeter 4. Drag the red and black measuring probes from the voltmeter so that each probe is connected to a different plate 5. Check that the voltmeter screen reads 0V to begin 6. Carefully change the value of the voltage by adjusting the button shown on the battery 7. Record the value shown on the voltmeter and the corresponding value of E shown on the stored energy bar 8. Repeatfor5morepositivevalues,upto1.5V 9. Plot a graph of E and against V2 to find the gradient 10.Given that = ( ) 2, calculate 2 Task 2 Knowing that: = 0 Where: 0 = permittivity of free space = 8.85 1012 = plate separation (distance in mm) = area of plate (m2) Calculate the plate separation required for a capacitance of 1.6 1013F and then compare to the experimentally found value. 1. Under the Meters tab on the right of the simulation window, select the following tick box: Capacitance 2. Using the same plate area as before (100mm2) as before, adjust the separation until 1.6 1013F is measured please also look at the attached files there are very important because it will tell exactly how do the experiment online and also the forof the essay
Use the order calculator below and get started! Contact our live support team for any assistance or inquiry.
[order_calculator]